Phaser 6250
  > Support
  > Knowledge Base
  > FAQ
  > Drivers

Support Topics
Step by step guides
  >  Errors, Jams, Failures and Other Messages
  >  Print Quality Problems
  >  General Information
  >  Installing and Setting Up the Printer, Networking
  >  Other Printing Problems
How To
  >  Install Printer Drivers
  >  Printer Setup
  >  Load Paper Trays
  >  Replace Consumables (Toner, Imaging Unit, etc.)
  >  Use the Front Panel



The Printer is Turned on, but Displays no Power, Lights, or Sounds; the Power Cycles On and Off
Step 1
 Verify the printer's power source
Solution: Isolate the printer to eliminate all other possible causes

Networks and peripheral devices can cause a wide range of unusual symptoms. To verify that the problem you are experiencing isn't being caused by the printer, perform the following steps.

  1. Turn off the printer.

  2. Disconnect all cables from the back of the printer, except for the power cord.

  3. Check and reseat the configuration card if installed.

  4. Turn the printer on and print any internal page from the printers front panel. A Menu Map, or any other page will do. If the page prints the symptom is likely caused by one of the network or peripheral connections and it is not a printer hardware problem.

Did this article solve your issue?
> Yes, that answered my question. I'm finished

Solution: Turn the printer off, wait 30 seconds and turn the power back on

Cycle Power

  • Turn the printer off, wait approximately 30 seconds and then turn the power back on.


Did this article solve your issue?
> Yes, that answered my question. I'm finished


Document ID: R1003023895

Direct URL to this document (to bookmark this page)
Need Help?
Send a message to a member of our Support Team for further help, and please register your printer first if you have not already done so.